Firmware BraveLLW - Alphatech (en)

Go to content

Main menu:

Firmware BraveLLW

Firmware for BraveLLW
Firmware is the communicator BraveLLW changed with program BraveLLWSet and USB cable NUDV.
Communicator must be connected to the telephone line!!!
Do not make unnecessary changes to the firmware (if you do not have a problem), any interference increases the risk of damage to the product.
Do not make unnecessary changes to the firmware (if you do not have a problem), any interference increases the risk of damage to the product.

Pleas use for Firmware upgrade PC program BraveLLWSet !!
Procedure step-by-step:
1 - Disconnect from the line Brave
LLW
2 - PC to install the program Brave
LLWSet (CD or  WEB - you must unzip)
3 -
Execute BraveLLWSet
4 - In the menu Option - Upgrade FW   choose file with FW (you must unzip - *.HEX)
5 - Connect the line BraveLLW
6 - Start programming FW
7 - It takes about 10 minutes - on end is message " pugrade is successful"
8 - If an error occurs, then disconnect communicator from the line, restart the PC program and repeat steps 4...7

V4.8     - 12.6.2017  repair small bug in programm

V4.5     - 6.1.2015   Added a new function for input "Blocking" - par.34 = 0/1 is the normal function of blocking (choice of polarity),

                                 par.34 = 2 is a new feature = "Engineer is present on the elevator," advent = activation of input blocking

                                 and sends the DTMF code  ** departure = input open and lock the communicator sends the DTMF code * #

                                 Repair constant at par. 58
                                 Adjusting for Talker module as parameter 64
                                 Added ability to detect sounds less than 150ms detector instead of 40 ms runs in a loop 20ms
                8.6.2016 - reparied Mute function (par.64)


V4.4     -  4.8.2014     - Repair message send after handup

                                 - Message location H2 send after DTMF   * # #
                                 - Mute microphone (par.64) to the confirm call (green LED)
                                 - Repair repeat call if is set number of repeat emergency call = 1 (par.35)

                8.6.2016 - reparied Mute function (par.64)

V4.2     -
1.4.2014    - Repaired write confirmation to the telephone number from DTMF
                                 - Support for three types of announcements from Talker module
                                 - Mute microphone by DTMF dial

V4.0
      - 16.10.2013 - change constants in detector of ring (25Hz+cadence)
              - 14.02.2014 - Disable light yelow LEDs at dialing  for call to machine room
              -
31.03.2014 - Repaired write confirmation to the telephone number fromn DTMF

V3.8       - first version for mass produce  (28.8.2013)

Last change: 29.1.2020
JR2011-2018
Back to content | Back to main menu